Here is a summary of what each page does. For more information on a page, click the link:
Connect Page – The initial page with connect options. The firmware version will display here when connected. You can click the Help button to get program help. You can also access help for any page by pressing F1 with that page displayed.
Time Page – You can set or get your mount’s time and time zone. You can also set a simulated meridian delay on this page.
Site Page – You can define the longitude and latitude of sites you visit. You can also get the longitude and latitude currently set in your mount. The sites you define on this page can be set up automatically when you unpark your mount in the Park/Rate Page.
Park/Rate Page – You can set your tracking rate with one of the built-in rates the mount supports (sidereal, lunar, solar, zero).
You can also do a one-button unpark and park of your mount. When parking, you can have your mount slew to one of the AP Park Positions or an Alt/Az of your choice.
Lastly, you can set up a delayed stop of your mount when imaging. This will stop the mount after a number of hours so that your mount will not hit the pier if you fall asleep or forget to stop it.
Guide/Slew Page – You can set the mount’s guide, centering, and slew rates. You can move the mount around with buttons. You can do a GOTO to a RA/Dec coordinate or SYNCH on a RA/Dec coordinate.
Pulse Guider Page – You can use the pulse-guiding feature from this page.
PG Config Page – You can adjust the pulse-guiding configuration parameters from this page.
PEM/Other Page – You can record a periodic error (PEM) cycle, turn on and off PEM, control focus through the AP focus port, adjust reticle brightness, and set RA and Dec backlash.
TPoint Page – This page allows you to resynchronize with your Software Bisque TPoint model, should you accidentally move your scope by hand or otherwise loose synchronization.